ARGOX X 2000V PPLB DRIVER DOWNLOAD

Change settings via buttons on panel: Put the media end on the roller. Make sure the coating side of the ribbon is face down. Transmission Problems If the host shows “Printer Time out” 1. Release the button when the cutter starts cutting. It also badly handles the situation where a printer driver is already in use by a Windows application.

Uploader: Faerg
Date Added: 24 April 2012
File Size: 43.53 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67718
Price: Free* [*Free Regsitration Required]

The other end of the cable connects to a serial port on the host computer.

Such proprietary information may not be used, reproduced, or disclosed to any other parties for any other purpose without arhox expressed written permission of Argox Information Co. Turn off the printer; disconnect the AC power cable. Connect the Parallel cable, Serial cable, or Ethernet cable to the proper port on the printer and on your computer.

Figure 1 Figure 2 76 B. For labels with gaps, label sensor argpx be positioned wherever media locates. To change setting to ribbon would ink-side out, refer to Section – Switching Ribbon Wound Ink-side out or Ink-side in 1.

Roll-feed, die-cut, continuous, fan-fold, tags, ticket in thermal paper or plain paper and fabric label.

Turn off the printer before cleaning. Scan product name and number from printed bar codes using the barcode reader. Printer finds the first label gap when print head is closed.

  DYNEX 5.1 CHANNEL PCI SOUND CARD WINDOWS 7 DRIVER DOWNLOAD

Off — direct thermal mode with no ribbon installed. The other end of the parallel interface cable connects to the printer connector at the host computer. Figure 2 13 2 Head Latch Bracket 3. Delete by application software for those no longer in use. The manual includes a guide to operate the printer as well as related information on troubleshooting, maintenance, and technical reference.

The CD-Rom will bring out the following prompt.

Argox X Industrial Label Printer.

Printer performs Auto Calibration after printing the first label, if label height differs from parameters in printer’s flash. Reflective MovableTransmissive Movable. Refer to the following examples. Isolate the power cord from other electrical cables.

Argox X |

After cutting, the printer will feed the label for 8 inches. However, please be noted, too much tension at ribbon supply argo result in ribbon not moving smoothly. Insert the left side of dispenser bracket and secure the three screws to the TPH module. Key-in the product name and number.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. If the test print appears as Figure B, remain the screw at the left of Ribbon Bracket fixed, and then loose the screw at the right, and gradually fine-tune upward, until the print quality gets improved.

  EASYCAM PLUS DRIVER

Seagull Argox X-2000v PPLB Free Driver Download (Official)

Figure 2 2 Print Head Module 3. Select next function setting. Make sure the coating side of arfox ribbon is face down. Cleaning the Roller Using a cotton bud moistened with alcohol, clean the roll and remove any attached glue. The default setting when 2000b from Argox factory is shown as Figure 2 — the two arrows are in line with the black line.

It decides which setting method – by command or by LCD panel, is prior. Printer performs Auto calibration when print head is closed.

Even though the “Add Printer Wizard” is from Microsoft, it too easily performs a number of tasks incorrectly when updating existing drivers. If problem continues perform a label sensor calibration.

Author: admin